【Performance】

◆ It is clear, little taste liquid .It is used conveniently.
◆ Appearance of adhesive dried quickly after painting. Touching shows powerful initial adhesive force.
◆ Have widespread applications. Can bond many materials such as a part of metals.
◆ Be suitable for bonding flexible body. Can moderate stress concentration caused by expansion or contraction.
◆ Have good heat resistance. Can be used at －40℃~60℃ after full dry and cure.

【Specification】

【Operation instructions】

◆ Remove oil and dirt on the wanted surface, then rough and dry it.
◆ Paint evenly from inside to outside on the wanted surface with brush or scraper (if large areas are bonded, please paint on the two wanted surfaces at the same time), then dry in the air at room temperature for 5~15 minutes (based on not adhering to hands)。
◆ After aiming at the wanted surface, extrude air bubble from inside to outside and beat with rubber hammer or wood hammer. The wanted strength is achieved after 24 hours.
◆ Be mainly used for room decorating. Not be suitable for being used in the place of the sun outside. If being used outside, it should be after adhesive liquid fully dries and cures for 72 hours. If bonding outside, it should take shelter from the light after full dry and cure .If being used at low temperature , it should be after full dry and cure.
◆ Because bonded materials on sale are various, the convenient bonding methods do not meet some special materials. Thus bond of higher permeable density board should be carried out two times. The wanted higher permeable part is painted and after adhesive appearance dries and hardens completely, then do it like this again. Finally, bond by the convenient method. It turns out that higher permeable density board is bonded tightly with other materials.
◆ Amounts of adhesive used are about 180 g to 260 g according to the bonded material.
◆ Adhesive liquid with higher viscosity can be diluted by gasoline (120#).

【Notes】

◆ The other side of the wanted material must be handled with hydrogen peroxide solution or nitrocellulose lacquer thinner before painting.
◆ The product is inflammables and used in the place of fireproofing and airiness.
◆ Keep out of the reach of children, not to be taken orally.
◆ Transport and store as inflammables, far from the fire and heat. Must not expose to the sun. Vacuous packing tub is far from the fire.
◆ Be mainly used for room decorating. Not be suitable for being used in the place of the sun outside.
◆ When opening it press lid with hands to protect adhesive liquid from coming out.
◆ Age in use is one year at room temperature. If it does not go bad beyond this period, adhesive liquid can be used continuously.

【Performance data】